Атомная энергетика| Nuclear power plants
Final Certification |Итоговая Аттестация
Lesson 6
Read the text: How a nuclear reactor works
How a nuclear reactor works. A nuclear reactor exploits the innate instability of some atoms—in
general, those that have a large atomic number or that contain an imbalance of protons and
neutrons—which break apart (fission) at random times, releasing photons, neutrons, electrons, and alpha particles. For some nuclides (atomic species having a specific number of protons and neutrons n the nucleus), the average wait until a given atom spontaneously fissions is shorter. When enough atoms of such an unstable isotope are packed close together, the neutrons released by fissioning atoms are more likely to strike the nuclei of nearby unstable atoms. These may fission at once, releasing still more neutrons, which may trigger still other fission events, and so forth. This is the chain reaction on which nuclear reactors and fission-type nuclear bombs depend. In a reactor, however, the fission rate is approximately constant, whereas in a bomb it grows exponentially, consuming most of the fissionable material in a small fraction of a second.
To produce a sustained chain reaction rather than a nuclear explosion, a reactor must not pack its
fissionable atoms too closely together. They are therefore mixed with less-fissionable atoms that do not sustain the chain reaction. For example, in a reactor utilizing 235U as its primary fuel, only 3 percent of the fuel is actually 235U; the rest is mostly 238U, a much less fissionable isotope of uranium. The higher the ratio of active fuel atoms to inert atoms in a given fuel mix, the more "enriched" the fuel is said to be; commercial nuclear power plant fuel is enriched only 3 to 5 percent 235U, and so cannot explode. For a fission bomb, 90 percent enrichment would be typical (although bombs could be made with less-enriched uranium). Naval nuclear reactors, discussed further below, have used fuels enriched to between 20 and 93 percent.
Having diluted its active fuel component (e.g.,235U), a typical nuclear reactor must compensate by assuring that the neutrons produced by this diluted fuel can keep the chain reaction going. This is done, in most reactors, by embedding the fuel as small chunks or "fuel elements" in a matrix of a material termed a "moderator." The moderator's function is to slow (moderate) neutrons emitted by fissioning atoms in the fuel. Paradoxically, a slow neutron is more likely to trigger fission in a uranium, plutonium, or thorium nucleus than a fast neutron; a moderator, by slowing most neutrons before allowing them to strike nuclei, thus increases the probability that each neutron will contribute to sustaining the chain reaction. Graphite (a form of pure carbon), water, heavy water (deuterium dioxide or 2H2), and zirconium hydride can all be used as moderators. Ordinary water is the most commonly used moderator.
If the chain reaction sustained by a nuclear reactor produces enough heat to damage the reactor
itself, that heat must be carried off constantly by a gas or liquid as long as the reactor is operating.
Once removed from the reactor, this energy may be ejected into the environment as waste heat or
used, in part, to generate electricity. (Electricity, if generated, is an intermediate energy form; all the energy generated in a nuclear reactor or other power plant eventually winds up in the environment as heat.) In the case of a nuclear-powered rocket, such as the one the U.S. National Aeronautics and Space Administration (NASA) seeks to develop with its Project Phoenix, heat is removed from the system by ejected propellant. Liquid sodium, pressurized water, boiling water, and helium have all been used as cooling media for nuclear reactors, with pressurized or boiling water being used by commercial nuclear power plants. Typically, heat energy removed from the reactor is first turned into kinetic energy by using hot gas or water vapor to drive turbines (essentially enclosed, high-speed windmills), then into electrical energy by using the turbines to turn generators.
Nuclear power sources that do not produce enough heat to melt themselves, and which therefore
require no circulating coolant, have been used on some space probes and satellites, both U.S. and
Russian. Such a power source, termed a radioactive thermoelectric generator or RTG, consists of a mass of highly radioactive material, usually plutonium, that radiates enough heat to allow the
generation of a modest but steady flow of electricity via the thermoelectric effect. The efficiency of an RTG is low but its reliability is very high.
1. Match the left part with the right:
1. This is the chain reaction on a) enriched to between 20 and 93 percent.
2.Nuclear power sources that do not b) produce enough heat to melt
themselves.
3. They are therefore mixed with less-fissionable atoms c) which nuclear reactors
and fission-type nuclear bombs depend.
4. Naval nuclear reactors have used fuels d) that do not sustain the chain reaction.
2. Complete the sentences with the suggested words: increases, fast, contribute, slow, most
Paradoxically, a ______ neutron is more likely to trigger fission in a uranium, plutonium, or thorium nucleus than a _______ neutron; a moderator, by slowing ______ neutrons before allowing them to strike nuclei, thus _________ the probability that each neutron will ________ to sustaining the chain reaction.